Dynasonics TFXL Clamp-On Ultrasonic Flow User Manual download pdf (Page 28)

28 06-TTM-UM-00158 8/2012

TFXL ERROR CODES

Revised 5-25-2009

Code Number Description Correction

Warnings

0010

Signal Strength is below Signal Strength

Cuto entry

Low signal strength is typically caused by one of the

following:

 Empty pipe

 Improper programming/incorrect values

 Improper transducer spacing

 Non-homogeneous pipe wall

0011

Measured Speed of Sound in the liquid is

greater than ±10% di erent than the value

entered during meter setup

Verify that the correct liquid was selected

in the BASIC menu.

Verify that pipe size parameters are correct.

Class C Errors

1001 System tables have changed

Initiate a meter RESET by cycling power or by selecting

SYSTEM RESET in the SEC MENU.

1002 System con guration has changed

Initiate a meter RESET by cycling power or by selecting

SYSTEM RESET in the SEC MENU.

Class B Errors

3001 Invalid hardware con guration Upload corrected  le.

3002 Invalid system con guration Upload corrected  le.

3003 Invalid strategy  le Upload corrected  le.

3004 Invalid calibration data Re-calibrate the system.

3005 Invalid speed of sound calibration data Upload new data.

3006 Bad system tables Upload new table data.

Class A Errors

4001 Flash memory full Return unit to factory for evaluation

TABLE A5.1  TFXL ERROR CODES

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

No comments

Dynasonics TFXL Clamp-On Ultrasonic Flow User Manual Page 28